What is post-curing treatment?
Introduction Post-curing is a critical thermal process […]
Integration of 3D Printing and Injection Molding Technology
Introduction 3D printing and injection molding each hav […]
Why do you choose pps plastic for bus bar?
Introduction In the electronics and electrical industri […]
Influence of current distribution on uniformity of chromium plate process
Introduction In the electroplating process on plastic i […]
How to avoid “floating fiber” phenomenon?
Introduction Fiber float is a common appearance defect […]
Do injection molded parts avoid “undercut” after spraying?
Surface Pretreatment Essentials Injection molded parts […]
Back-off or complicated demoulding method in products
Reverse and complex ejection methods are common design […]
How Are TPE Properties Achieved Through Injection Molding?
TPE (Thermoplastic Elastomer) is a material widely used […]
The difference between “over-baking” and “under-baking” in injection molding.
In the injection molding process, the phenomena of &quo […]
How can we avoid plasticizer “migration”?
Plasticizers are widely used in injection molded produc […]
